How to Clean Your ABS Wheel Sensor

Oct 19, 2008

Does your ABS light come on consistently and you do not know what is wrong! Well, when you check your code, you may see that it says that your front wheel sensor is damaged. However, that is not always the case. A lot of times, your ABS wheel sensor is just fine; they just need to be cleaned. Of course, if you take it to a shop, they are going to tell you that you need a new one. So we are going to go over how you can clean your own ABS wheel sensor in your Toyota and save yourself a lot of money. After you clean it, if you are still having the problem, you will need a new one. However, most people have noted that nine times out of ten, this does indeed fix their problem.

First of all, before you get started, you are going to want to make sure you have everything that you need to perform the job. The only things that you are really going to need are a ratchet, jack, wheel lock and, of course, a rag or paper towel to clean it off with. After you have all of this stuff, you can feel free to get started. This should only take you an hour or two to do yourself......

Getting Started On Your Wheel Sensor

First, you have to choose which side you want to get started on. You can choose either the passenger side or the driver side; it does not really matter. However, whichever side you do choose, that is the side that you, of course, need to jack up first. Before you jack up the car, you need to turn the steering wheel to the opposite side that you are working on. For example, if you are working on the driver side, then you are going to want to turn the wheel to the passenger side. Also, when you get it jacked up. You should use a jack stand, not just the jack. You never know how long you will need to have this car jacked up, so you will want the jack stand.

After you turn the wheel and get everything all set up, you will notice that you should be able to locate the ABS wheel sensor very easily. It should be located directly mounted to the knuckle. To take this off, you are going to have to remove the two bolts that are holding them in place. In most Toyota cars, they are 10mm bolts. However, some of them can change from time to time. Overall, there will be about four bolts you have to take out. To do this, just follow the ABS sensor around so that you can remove all of the bolts. When you get the sensor off, you will notice that it is all covered in dirt. Take your rag or paper towel, and start whipping it off. As you do, you will notice that the very middle of it has a sliver strip that you could not see before. A lot of times, dirt blocks this and can cause problems, as you found out. After cleaning it, simply reverse the steps you did to reinstall it. Also, be sure to check both of the front ABS sensors. The one on both sides of the car!

Still Having Problems

Most of the time the procedure discussed above will fix any problem that you are having with your ABS sensor. If you have cleaned both of the front sensors and there are still problems, then you do have a damaged ABS sensor. At this point, you need to get new ones and replace them. If you want, you will be able to install them the same way you cleaned the other ones. However, instead of cleaning the old ones and putting them back on, you can simply put on the new ones. Overall, this is a one day job that can save you a ton of money. Most people do not notice how much money that they can save by doing this themselves until they actually do it!

Featured Links:

+ Dummy Health Guide for Malaysian
+ Dating and Relationship Blog
+ Malaysia Real Estate Blog
+ GeekMalaya - Malaysia Computer and Technology Blog

Mantius Cazaubon is a successful author and publisher of Toyota Parts Buyers Guide, A resource which includes information on Discount Auto Parts and DIY Auto Repair


Anonymous said...

The article was very interesting and informative for me. weight loss Read a useful article about tramadol tramadol